- The angle measures the OPENING between two sides from the vertex — never the arm length.
- Benchmarks: right 90° (set square), straight 180°; acute = below 90°, obtuse = in between.
- The protractor: centre on the vertex, zero on one side, read the scale STARTING at zero — the eye classifies first.
An Opening Measured in Degrees
An ANGLE measures an OPENING: two rays (the SIDES) leave one point (the VERTEX), and the angle says how far apart they open — in DEGREES, with the PROTRACTOR as instrument. The official notation: three letters under a hat, angle ABC, the vertex ALWAYS in the middle — B is the tip, A and C live on the sides. The reference vocabulary hangs on two benchmark angles: the RIGHT angle (90°, the set square) and the STRAIGHT angle (180°, the ray continued); around them: ACUTE (between 0 and 90° — sharp), OBTUSE (between 90 and 180° — open), and the full turn at 360°. The founding truth of the chapter, counter-intuitive and capital: an angle does NOT depend on the length of its sides — extending the arms of an angle does not open it by one degree: two pairs of scissors opened alike make the same angle, short blades or long.
Vocabulary and Benchmarks
| The Angle | The Measure | The Everyday Anchor | The Detail That Counts |
|---|---|---|---|
| The zero angle | 0° | Closed scissors | Both sides coincide |
| The acute angle | Between 0° and 90° | The pizza-slice tip | "Acute" as in sharp |
| The right angle | Exactly 90° | The sheet corner, the set square | The little square on the figure certifies it |
| The obtuse angle | Between 90° and 180° | The reclined deckchair | Wider than the set square, not yet flat |
| The straight angle | 180° | The ruler laid flat: a line | Two right angles end to end |
| The notation | Three letters, vertex in the MIDDLE | Angle ABC: the tip is at B | Angle BAC has its tip at A: another angle! |
An angle of 132° is…
Classification goes by the MEASURE, never by visual impression: 132° exceeds the set square (90°) without reaching the flat ruler (180°) — obtuse. A badly drawn figure can make an open angle look sharp: the number rules.
The Protractor, User Manual
Measuring in three moves: 1° the CENTRE of the protractor on the VERTEX; 2° the ZERO of one scale aligned with ONE side; 3° read where the OTHER side crosses — following the scale THAT STARTS AT ZERO (the protractor carries two, running opposite ways: the one starting at 0 on your side is the right one). The sanity check before writing: does the angle look smaller or bigger than the set square? A visibly acute angle measured "130°" flags the wrong scale — the eye cannot measure, but it can classify.If the sides are too SHORT to reach the scale: EXTEND them with the ruler — perfectly legal, since the angle does not depend on arm length: extending changes the opening by nothing. It is the founding truth applied, and the move that saves half of all measurements on small textbook figures.
The Long-Arms Trap — and the Double Scale

Two 45° angles: one has 2 cm sides, the other 10 cm. Which is bigger?
The founding truth: the angle measures the OPENING. Lengthening or shortening the sides changes nothing about the 45° — two scissors opened alike, short blades or long, make the same angle. Wingspan impresses the eye, never the protractor.
Case File: The Sundial










- The angle measures the OPENING between two sides from the vertex — never the arm length.
- Benchmarks: right 90° (set square), straight 180°; acute = below 90°, obtuse = in between.
- The protractor: centre on the vertex, zero on one side, read the scale STARTING at zero — the eye classifies first.
- Sides too short: extend with the ruler, in full legality.
- Notation: three letters, vertex in the MIDDLE — angle ABC has its tip at B.




